RC8B3.2/3.1 2-Row Tall Carbon Rear Tower

**in stock and shipping now**  (updated June 17, 2019)

Developed for both electric and nitro RC8B3.2 / 3.1 series buggies, the 2-Row Carbon Rear Tower has a 2nd upper row of mount holes to move the entire shock when running Low Roll Center on the rear hubs (the hinge pin close to the rear axle, commonly called "hubs down").   Shifting the shock along with the axle height on the rear hinge pin gives the advantage of more up-travel.    In bumpy conditions on hard cornering, the additional travel helps the tires to navigate the surface without bottoming the shock and upsetting the chassis.   The lower row of holes matches the kit geometry and is intended for running in the HRC axle height on the rear hub.

• 2nd "tall" upper row of shock mounts to keep the same geometry for running LRC "hubs down".
• Made from quality 4mm thickness 100% carbon fiber (weight 18g).
• No pockets prevents de-lamination.
• Larger hole spacing increases durability.
• Works with kit length shock shafts (truggy shaft not required)
• Fits RC8B3.2, 3.2e, and older RC8B3 versions

Pro Tip:  Run shock total length 123.5mm for upper row of holes when setting droop.  Measure center to center on the mount screws.   Truggy shock shafts not required, but recomemmended for more stable performance in long mains.

Recent results:

2019 Broc Champlin ROAR Nationals A-Main

2019 May JBRL Winner,  Victorvillle, CA (Richard Saxton)

2019 LoneStar Classic A-Main 40+ and Intermediate Buggy (Kurt Wenger, Rob Allen)

2019 Pro-Line Shootout 40+ eBuggy Winner (Kurt Wenger)